Skip to Content
EIS

3CX

Essential parameters to register the trunk and associate the DID

This procedure concerns a SIP Trunk EIS in mode Registration. Before starting recovers from Hive username, password and numbering associated with the trunk.

Add the trunk

In the 3CX panel open SIP Trunk and select Add SIP Trunk.

Set the registrar

Use sip.teameis.it as a trunk recorder.

Configure Authentication

Select the account-based mode and enter username and password displayed in Hive.

Check out calls

Configure outbound parameters and composition rules based on the numerical format provided by your call plan.

Add the DID

Enter in the DID section all numbers associated with the trunk and connect them to the desired internal destinations.

Testing

  • verify that the trunk status is registered;
  • calls each DID from an external line;
  • run an outgoing call and check the number presented;
  • verify the audio in both directions;
  • check that firewalls and NAT do not misuse signals and media.

The interface entries can change between 3CX versions. See also the original 3CX guide on EIS Wiki.

On this page